This was a very disappointing outcome. I've thought it'd be more dramatic than the previous one. However, this can be considered an improvement in the sense that the central part needn't be cut as in the earlier one.
This had been a real painful experience. It was a 36 sided regular polygon in the inside and 72 sided one on the outside(same as the previous one). I had to redraw the entire crease pattern on the paper due to a "little" calculation mistake and I was on the verge of giving up. It was Then I took time to let off the steam and redid the CP again. Now I got it right.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment